Hobart Welding Products Handler 140 Owner's Manual

Welding System
πŸ“–  Manuals supported for 3 models of Hobart Welding Products
  • Handler 180
  • H-10 Gun
  • Handler 135
Table of Contents
  • SECTION 1 βˆ’ SAFETY PRECAUTIONS - READ BEFORE USING

    5
  • Additional Symbols For Installation, Operation, And Maintenance

    7
  • Principal Safety Standards

    8
  • Signification des symboles

    9
  • Autres symboles relatifs Γ  l'installation, au fonctionnement et Γ  l'entretien de l'appareil

    11
  • Principales normes de sΓ©curitΓ©

    12
  • SECTION 3 βˆ’ DEFINITIONS

    13
  • Duty Cycle And Overheating

    14
  • Volt-Ampere Curves

    15
  • SECTION 5 βˆ’ INSTALLATION

    16
  • Process/Polarity Table

    17
  • Installing Gas Supply

    18
  • Selecting A Location And Connecting Input Power For 115 VAC Model

    19
  • Selecting A Location And Connecting Input Power For 230 VAC Model

    20
  • Electrical Service Guide For 230 VAC Model

    21
  • Threading Welding Wire

    22
  • SECTION 6 βˆ’ OPERATION

    23
  • Weld Parameter Chart For 115 VAC Model

    24
  • Weld Parameter Chart For 230 VAC Model

    26
  • SECTION 7 βˆ’ MAINTENANCE &TROUBLESHOOTING

    28
  • Changing Drive Roll Or Wire Inlet Guide

    29
  • Cleaning Or Replacing Gun Liner

    30
  • Replacing Switch And/Or Head Tube

    31
  • Troubleshooting Table

    32
  • SECTION 8 βˆ’ ELECTRICAL DIAGRAM

    33
  • SECTION 9 βˆ’ MIG WELDING (GMAW) GUIDELINES

    35
  • Typical MIG Process Control Settings

    36
  • Holding And Positioning Welding Gun

    37
  • Conditions That Affect Weld Bead Shape

    38
  • Gun Movement During Welding

    39
  • Troubleshooting βˆ’ Excessive Spatter

    40
  • Troubleshooting βˆ’ Lack Of Penetration

    41
  • Troubleshooting βˆ’ Waviness Of Bead

    42
  • Common MIG Shielding Gases

    43
  • Main assembly parts list & view

    46
  • Optional drive rolls/options parts list

    50

Related manuals