NiceUC NC-AD300E User Manual

Manufacturer
Type
Pages 64 Pages
Updated Sep 3, 2021
Category PBX

Table of Contents

  • Foreword

    2
  • Chapter 1 Overview

    5
  • Interface description

    6
  • Hardware specification

    8
  • Chapter 3 Installing Equipment

    9
  • Enviroment

    11
  • Setup step

    13
  • Terminal connection

    14
  • Command States

    15
  • Modify the boot parameters

    16
  • Device IP Address

    17
  • Modify the IP address

    19
  • Chapter 5. Software configuration

    20
  • Connect device

    21
  • Write device parameters

    22
  • Operation configuration

    23
  • E1 Configuration

    24
  • PCM property

    25
  • SS7 Signaling

    28
  • V5.2 signaling

    29
  • Analog Line Configuration

    30
  • Analog Signal Set

    31
  • Call Detection Settings

    32
  • Call control

    33
  • Routing Rule

    34
  • Groups

    42
  • Function Deployment

    43
  • Subsriber line Number Configuration

    44
  • Hot number

    45
  • Number Convert

    46
  • Chapter 6 Calling detail records

    47
  • Txt format

    49
  • Chapter 7. Debug monitor

    50
  • Equipment Command

    51
  • Calling trace

    53
  • Appendix 1. The use of Hyper Terminal

    56
  • Appendix 2. To establish FTP services

    58
  • Appendix 3. Recording tone and load to PBX

    59
  • Appendix 4. Equipment software upgrades

    61
  • Appendix 5. Equipment software upgrades

    62
  • Appendix6.SS7signaling messages introduction

    63