Holip HLP-A100 Series Operating Manual

Holip

Inverter


Advertisement

Table of Contents
  • Introduction

    8
  • During the power-up

    10
  • After the power-off

    11
  • Chapter 2 Standards and Specifications

    12
  • Particular Specifications

    13
  • Technical Specifications

    14
  • Chapter 3 Installation and wiring

    18
  • Dimensions of the inverter

    19
  • Installation and Wiring

    20
  • Installation and Direction

    21
  • Wiring terminal

    22
  • Wiring

    26
  • Chapter 4 Operation and Display Interface

    28
  • FWD/REV Status

    29
  • Data read-outs

    30
  • View alarm record

    32
  • View state parameter

    33
  • LED Display

    34
  • Chapter 5 Parameter Overview

    35
  • Chapter 6 Parameter Description

    61
  • Parameter Group 01: Load and Motor

    66
  • Parameter Group 02: Brakes

    76
  • Parameter Group 03: Reference/Ramps

    79
  • Parameter Group 04: Limits/warnings

    88
  • Parameter Group 05: Digital Input/Output

    93
  • Parameter Group 06: Analog In/Out

    102
  • Parameter Group 07: Controller

    110
  • Parameter Group 08: Comm. and Options

    113
  • Parameter Group 13: Simple PLC

    117
  • Parameter Group 14: Special Functions

    125
  • Parameter Group 15: Drive Information

    130
  • Parameter Group 16: Data Readouts

    134
  • Parameter Group 25: App. Functions Cascade

    143
  • Parameter Group 30: App. Functions Wobble

    152
  • Chapter 7 Quick Application Guide

    157
  • Using digital in terminals to control the drive [AUTO]

    158
  • Potentiometer reference

    159
  • Reference for pulse input

    160
  • Speed up/down

    161
  • Pulse start/stop

    162
  • Configuration Mode

    163
  • Simple PLC

    165
  • Parallel Execution

    167
  • Chapter 8 Accessory Specification

    168
  • Chapter 9 EMC

    170
  • Chapter 10 Warnings/Alarms and Fault Handling

    171
  • Fault Indication and Trouble Shooting

    175
  • Chapter 11 Maintenance

    177
  • Chapter 12 Communication protocol

    178
  • Read Coil Status

    180
  • Read Holding Registers

    181
  • Force Single Coil

    182
  • Force Multiple Coils

    183
  • Preset Multiple Regs

    184
  • Read/Write array

    185
  • Exception code

    186