Concurrent Technologies VP 110/01x VME Pentium III-M Single Technical Reference Manual

Notational conventions

Table of figures

The vp 110/01x - main features

Pci busses

Floppy disk

Additional board options

Hardware installation

Unpacking and inspection

Default jumper settings

Front panel indicators and controls

External reset

Installation of on-board mass storage

Adding or replacing dram modules

Installing and replacing the battery

Installing or removing a pmc module

Installing the board in a vme backplane

Software installation

Bootloading from cd-rom

Using vxworks 5.4 with tornado

Floppy disk interface

Eide interfaces

Rom disk

Ram disk

Vme bus interface features

Vme byte swapping

Vme bus error interrupt

Vme address capture control register (write only)

Serial port

Keyboard and mouse ports

Real-time clock

Universal serial bus (usb)

Power on self test led/speaker

Flash eprom

Battery backed sram

Status & control register 0 (i/o address 210h)

Status & control register 2 (i/o address 211h)

Status & control register 1(i/o address 212h)

Watchdog timer

Watchdog status & control register (i/o address 214h)

Watchdog configuration

Status & control register 4 (i/o address 215h)

Memory page and status register (i/o address 216h)

Status & control register 3 (i/o address 217h)

Long duration timer/periodic interrupt timer

Long duration timer/periodic interrupt timer low byte

Ldt/pit status & control register

Programming the ldt/pit

The pc bios startup sequence

Boot device selection

Pci bus resource management

Pci device ids

Starting the master test handler

Bist execution

Mth command reference

Utility commands

Bist descriptions

Test 6: interconnect image check

Test 12: local ram fixed pattern test

Test 25: local ram dual address test

Test 39: watchdog test

Specifications