Extron electronics PVS 405D Installation Manual

Extron electronics

Switch

📖  Manuals supported for 1 models of Extron electronics

  • PoleVault PVS 405D

Advertisement

Table of Contents
  • Safety instructions

    2
  • Conventions used in this guide

    4
  • Introduction

    7
  • Application Diagram

    8
  • Americans with Disabilities Act (ADA Compliance

    9
  • Inventory — polevault digital system

    12
  • Kits

    13
  • WVS 200D

    14
  • WVS 210D

    15
  • PLS 200D

    16
  • PLS 210D

    17
  • Items Not Included

    18
  • Optional Items

    19
  • Installation

    21
  • Outline of Installation Steps for PoleVault Digital Systems

    22
  • Installing the Screen and Projector

    23
  • Mark Screen Location

    24
  • Verify the Image Location

    27
  • Cut the Ceiling Tile

    28
  • Finish Projector Drop Ceiling Mount Installation

    29
  • Secure the Projector Drop Ceiling Mount to the Ceiling

    30
  • Install the Electrical Box (if required)

    31
  • Mounting the PVT Wallplate and the MediaLink Controller

    33
  • Install the Mud Rings

    35
  • Pull the Cables (at the input locations)

    36
  • Installing the FF 120 Ceiling Speakers

    41
  • Cut Ceiling Tile

    42
  • Terminate the Speaker Cable for the PVS Switcher

    44
  • Installing the Switcher Mounting System and the PVS 405D

    45
  • A1. Install the PMK 560 Base Plate

    46
  • A2. Pull the Cables (at the Switcher location)

    47
  • A3. Secure the HDMI cables using the LockIt bracket

    48
  • A4. Finish installing the Mounting Kit

    49
  • B1. Install the WMK 160 Base Plate

    50
  • B2. Install the switcher onto the Base Plate

    51
  • B3. Run the cables to the WMK

    52
  • C1. Install the USFM 100 Base Plate

    54
  • If running cable behind the walls

    55
  • C4. Cable the switcher

    56
  • D1. Remove the device mounting plate from the access door

    59
  • D3. Suspend the main PVM

    60
  • D4. Run AC power wiring to the AC module in the PVM 220

    61
  • D5. Run signal and control cables to the PVM 220

    62
  • D6. Install devices onto the device mounting plate

    63
  • D8. Install the device mounting plate onto the access door

    64
  • D10. Verify and configure the setup

    65
  • Configuring the PVS 405D Switcher

    67
  • Test the System

    69
  • Final Installation

    71
  • VoiceLift System Included parts

    72
  • Installation Procedure

    74
  • Priority Page Sensor Kit Included Parts

    75
  • Testing and Adjustment Procedure

    78
  • Outline of Installation Steps for WallVault Digital Systems (WMK 160)

    79
  • Outline of Installation Steps for WallVault Digital Systems (USFM 100)

    80
  • Outline of Installation Steps for PlenumVault Digital Systems (PVM 220)

    81
  • Extron Warranty

    83

Related manuals