Table Of Contents
📚 Lenel OnGuard Hardware Installation Manual
-
TABLE OF CONTENTS
- Hardware Installation Guidelines
- Inputs, Outputs and Interface Signals
- Alarm Inputs
- RS-232 Interfaces
- System Wiring and Other Considerations
- Mounting
- Ground Wiring
- Alarm Input Wiring
- RS-232 Communication Wiring
- Relay Contact Protection
- System Turn-Up Considerations
- Ground Potential Difference Checks Before Connecting
- Maintenance
- Firmware Updates
- UL/ULC Certified Installations
- Power
- UL/ULC Requirements
- CAN/ULC-S319-05 Requirements
- EN Certified Readers
- Troubleshooting
- LNL-500 Intelligent System Controller
- Overview of the LNL-500
- Installation
- Configuration
- Installing Jumpers
- Specifications
- LNL-1000 Intelligent System Controller
- Overview of the LNL-1000
- The ISC Board
- LNL-2000 Intelligent System Controller
- Overview of the LNL-2000
- The LNL-2000 Board
- LNL-2210 Intelligent Single Door Controller
- Overview of the LNL-2210
- Default Login Security Enhancements
- Memory Backup Battery
- Setting Dip Switches
- Embedded Web Server
- Additional Mounting Information
- UL Listed Installations
- Specification
- LNL-2220 Intelligent Dual Reader Controller
- Overview of the LNL-2220
- The IDRC Board
- Default Settings
- Communication Wiring
- Reader Wiring
- Input Circuit Wiring
- Relay Circuit Wiring
- Initial IP Addressing Mode
- Replace Memory Backup Battery
- LNL-3300 Intelligent System Controller
- Overview of the LNL-3300
- Power and Alarm Inputs
- LNL-4420 Intelligent Dual Reader Controller
- Overview of the LNL-4420
- UL 294 Installations
- ISC Communications
- ISC Communication
- LNL-ETHLAN (MSS1/MSS100 Ethernet Controller)
- LNL-ETHLAN-MICR (Micro Serial Server)
- CoBox Micro 100
- CoBox Token Ring Serial Server (LNL-COBOX-201TR)
- Lantronix CoBox-DR
- Lantronix SecureBox SDS1100/1101
- Lantronix UDS-10/UDS100/UDS200/UDS1100
- Commonly Used Values
- LNL-IC108A/IC109A RS-232 to RS-485 Converter (4-wire)
- LNL-IC108A/IC109A RS-232 to RS-485 Converter (2-Wire)
- Configuring Two LNL-838A RS-232 to RS-485 Converters
- Dial-Up Configuration for the ISC
- Securcomm Uniflex DC336 Modems (12 VDC)
- Comtrol RocketPort Hub Si
- Jumper settings
- IFS Single/Multi-mode Duplex Data Transmitters Receivers (DFDMM001-TX and 7DFDMM001-RX)
- Safety instructions
- Led indicators
- LNL-1100 Input Control Module
- Overview of the LNL-1100
- The Input Control Module (Series 2)
- Elevator Control
- LNL-1100-U Input Control Module
- Overview of the LNL-1100-U Board
- Status LEDs
- Wiring
- Unsupervised Alarm Inputs: Power Fail and External (Cabinet) Tamper
- Upstream Controller Communication
- Control Output Wiring
- Power and Communications
- LNL-1200 Output Control Module
- Overview of the LNL-1200
- The Output Control Module (Series 2)
- LNL-1200-U Output Control Module
- Overview of the LNL-1200-U Board
- Upstream Communication
- Relay Outputs
- LNL-1300 Single Reader Interface Module
- Overview of the LNL-1300
- The Single Reader Interface Module Board (Series 2)
- LNL-1300e Single Door IP Interface Module
- Overview of the LNL-1300e
- Recommended Settings for PoE
- Configure Network Address to LNL- 1300e
- Using Static IP Addressing
- System Administration Configuration
- LNL-1300-U Single Door Controller Module
- Overview of the LNL-1300-U Board
- Downstream Reader Communication
- Open Supervised Device Protocol
- External (Cabinet) Tamper
- LNL-1320 Dual Reader Interface Module
- Overview of the LNL-1320
- The Dual Reader Interface Module (Series 2)
- LNL-1320-U Dual Door Controller Module
- Overview of the LNL-1320-U Board
- LNL-8000 Star Multiplexer
- Overview of the LNL-8000 Board
- The Star Multiplexer Board
- Wiring and Termination
- LNL-2005W Magnetic Card Access Reader
- Overview
- Grounding the Reader
- Reader Mounting Dimensions
- Reader Weather Shield
- Access Reader
- Weatherproofing the Reader
- DIP Switch/Jumper Setting
- Keypad Data and Tamper Monitor Signaling
- OnGuard Configuration
- Status Indicators
- Product Identification
- LenelProx Readers
- LenelProx LPMM-6800
- Reader interface
- LenelProx LPSP-6820
- LenelProx LPKP-6840
- Operating modes
- LenelProx LPSR-2400
- LenelProx LPRKP-4600
- LenelProx LPMR-1824 and LPMR-1824 MC
- LenelProx LPLR-911
- Lenel Keypads
- Lenel OpenCard Readers
- OpenCard XF1050-K
- OpenCard XF1500
- BlueDiamond Mobile Readers
- DirectKey Toolkit
- LNL-500B Biometric Reader Interface
- Overview of the LNL-500B
- The Biometric Reader Interface Board
- Supported Biometric Readers
- HandKey Readers
- MIFARE/iCLASS HandKey Reader
- Biometric Readers
- Overview of Biometric Readers
- MorphoAccess SIGMA Series Reader
- Configure to Read the Open Encoding Standard (DESFire) Application
- Bioscrypt 4G V-Station and V-Flex Readers
- G Configuration in SecureAdmin
- G Reader Interface Connections
- Wiring 4G Verification Readers
- G Reader Configuration in OnGuard
- Enrollment Configuration
- Encoding Configuration
- Bioscrypt 3G Series Readers
- V-Smart and V-StationG/H
- Led settings
- LNL-500W Wireless Gateway Interface
- Overview of Wireless Reader Interfaces
- Installation of the Gateway
- Use with the LNL-2020W
- Command Keypad
- LNL-CK Command Keypad Overview
- Hardware Revision and Firmware
- Wiring the Command Keypad
- DIP Switches
- Jumpers
- Status Display
- Command Programming
- Command Keypad Behavior
- Index
